1. Home
  2. Installing Cloud Control 2

Installing Cloud Control 2

Refer to this guide if you need help installing your Cloud Control module on your spa.

If you had purchased the Cloud Control 2 Module before your spa was delivered, start here. Otherwise, continu

Connecting the Module to the Router

Step 1 – Connecting the module to the router

Connect the module that came with your spa to the back of your router using the blue ethernet cable, (included with your module packaging) and plugging the module into the nearest outlet. If the module shows green, the device is properly powered and connected to your router.

If the module is connected to the router and remains red for more than 1 minute, unplug the router, and check if the blue ethernet cable is fully seated in the back of both the router, and the module itself. Plug the module back into the wall, and try again.

Once both modules are connected, the house module will go from red to blue, indicating that both modules have been paired. If the problem persists, unplug both the router and the module in order properly reboot both devices. reconnect both devices, and try again.

If you need to pair your modules again, push in the pairing button with a paperclip located above the LED light on the module connected to your router.

Step 2 – Setting up the Cloud Control 2 App

Proceed to download the Bullfrog Spas Cloud Control 2 app on your iOS or android device. For the first time setup, both your spa and mobile device need to be on the same WiFi connection.

On the Cloud Control 2 app, create an account and verify your email address. From there, select your spa on the screen. If there is no spa available, please check if your phone is connected to your WiFi. If the problem persists, please ensure both modules are blue, restart your app, and try again.

Creating an account will enable you to use your spa while you are away. If you have multiple spas, you can use the same account to control all connected spas as well.

You will then be directed to see the spa settings page. Hit the back arrow in the top left corner to now use your hot tub from your phone.

Connecting the Cloud Control 2 Module to the Spa

If you purchased the cloud control 2 module after your spa was installed, please begin here. Otherwise, navigate to the “Connecting the Module to the Router” section.

What you will need

  • Access to your router or an ethernet port
  • Screwdriver

To prevent any internal damage, please switch off the spa breaker while connecting the spa module.

Removing the Spa Door

Begin by removing the front strips of your spa. It’s typically easiest by pulling the bottom part of the strip towards you.

Remove the front panel door by pulling from the bottom. The door will disconnect from the internal clips on both sides, which will cause the entire door to slide down.

Disconnect any lights that may prevent you from placing the door to the side of your hot tub. Each light is attached via a silicon rubber sleeve. To remove, simply pull the lights away from the door.

Connecting the Module to the Spa

Remove the front shield from the motherboard. There are five screws, 2 on top, two on the bottom, and two on the sides. You don’t need to fully remove the screws for the shield to come free.

Grab the cable connecting to the control module, and connect it to the empty port on the bottom right of the motherboard.

On M Series spas, there may be a plastic piece protecting the inside of the slot. Remove to insert the module cable properly.

To ensure proper signal transmission, it may be necessary to change the position of the transmitter once the spa is installed in your spa. The transmitter should be located on the side of the spa facing the house.

Your spa module should now be ready to go. To keep the module out of the way, We have attached our module to the side of interior frame of the tub.

If you still have any questions or concerns, please text or call us at (801) – 737 – 4515 and we will be happy to assist you further.